|
PCI to SCSI Ultra Wide
Part number: EA-PCI-SCSI3
Adaptec model AHA-2940UW host adapter and Adaptec EZ-SCSI software.
Includes 68-pin UltraSCSI internal ribbon cable.
SCSI 50 to 68-pin adapter
Part number: ADP9050
Circuit board with 68-pin male SCSI connector on one side and
a 50-pin male narrow connector on the other.
Includes termination resistors for unused high order data lines.
BNC to Trompeter
Part number: ADBJ20-PL75
Plugs onto Trompeter CJ70 connectors on EmPack’s
front panel to accept BNC male connectors.
Separate adapters required for input and output lines. |
EmPack Power Plugs
Since the power consumed by the mezzanines can be significant,
each foundation and mezzanine board is equipped with a standard P1
disk drive power connector.
Our power plug enables a stack of one foundation and three mezzanine
boards or two foundation boards to be powered by either one or two
power cords.
A handle facilitates removal but can be removed if it interferes
with the mounting inside the host computer. Overall length of the
EmPack card cage with the power plug’s handle is ??".
If the stack of four EmPack cards consumes more than ??A,
a second power cord must be used.
Mezzanine Spacer
Part number: EBX1
Component height prevents an EmC12 from being mounted directly
above the foundation board (with T1 or E1) or directly above another
EmC12. A spacer must be inserted between an EmPCI and any mezzanine
above it to extend the bus connector. For example, the part number
for an EmPack foundation in a half-height card cage with only an
EmC12 mezzanine would be EHB2D2T1X1C2. |
